A pipe usually fails inside a wall cavity, which means the visible damage is only a fraction of what's actually happening behind the drywall.
We open the wall cavity carefully, only as far as moisture readings say is necessary, rather than tearing out an entire wall.
Our Doon, IA technicians locate the main or local shutoff valve immediately if it hasn't been closed already.
We use pressure testing and moisture tracing to locate exactly where a supply line failed inside the wall.
We open wall cavities in a controlled, targeted way based on documented moisture data.
Handoff to a licensed plumber is built into our burst pipe process, not left for you to arrange separately.
A burst pipe call has a specific sequence — find the source, stop it, open only what's necessary, and coordinate repair — here's how our Doon, IA crews run it.
We locate and confirm the shutoff valve is closed the moment the crew arrives.
We locate the failure point before opening any drywall, avoiding guesswork demolition.
Wall cavity extraction addresses moisture a surface-level approach would miss.
Saturated insulation is removed and replaced, while drywall is cut only at the confirmed wet line.
Drying continues until wall cavity moisture readings hit dry standard.
We coordinate scheduling with a licensed plumber for the pipe repair itself.
Tell our Doon, IA dispatcher if the water source is still running so we can advise on shutoff immediately.
Our nearest crew arrives ready to confirm shutoff and begin diagnostics.
You'll see the scope and cost once the failure point is confirmed.
We verify wall cavity moisture readings hit dry standard and confirm plumber repair is scheduled before closing the file.
"They found our shutoff valve in about thirty seconds since we had no idea it existed, then got straight to work on the wall." — Holly T.
"Only opened up the section of wall that was actually wet instead of the whole thing. Saved us a lot on drywall repair." — Andre L.
"They coordinated directly with our plumber so the pipe got fixed the same week the wall was already open." — Priscilla W.
We can confirm which you're dealing with during the initial assessment.
No, we remove drywall only at the confirmed wet line based on moisture readings.
Pipe repair is handled by a licensed plumber we coordinate with, while we manage extraction and drying.
If you can safely reach it, shut off the water at the main or local valve to stop the flow.
Wall cavity drying typically takes 3-5 days depending on how much insulation and framing was affected.
Doon sits within our core burst pipe response zone.
Speak directly with our burst pipe response team.
Call +1-844-578-1604